Craftsman 113.226421 - Installing Sanding Disc Plate; Installing Pulley Cover

PULLEYCOVER
INSTALLING PULLEY COVER
1. Locate the pulley cover and one screw
114-20xl-3f4".
,
Place pulley cover into position shown and
fasten with one screw. Do not overtighten.
INSTALLING SANDING DISC PLATE
1. Locate sanding disc plate, sanding disc, one
setscrew 1/4-20xl/4 inch, and a 1/8 inch hex
wrench.
2. Just start screw into threaded hole in sand-
ing plate.
SCREW 1/4-20X1-3/4
SANDING DiSC
HEXWRENCH
.... , ...................... !!==!t II ,. _ Iqll .......... ,, i i1,1
,
Align flat on shaft with setscrew in sanding
plate. Slide sanding plate onto shaft until
plate surface and shaft are nearly flush. Do
not allow shaft to extend out past surface of
sanding plate or damage may occur to your
sanding disc during operation.
SANDING
DRIVE PLATE
'] SHAFT //_,¢
I
GUARDNOT
SHOWNFOR
CLARITY
SANDING
PLATE
FLAT .1-..
(ONSHAFT)
.
To tighten setscrew, reach through hole in
top of pulley cover with hex wrench. Tighten
setscrew very firmly.
HEX
ENCH
SECTION OF
PULLEY COVER
REMOVED FOR
PICTURE CLAR;TY
9