Craftsman 113.226421 - Maintenance; Wiring Diagram; Lubrication

_:_:::iii:!ii!:::i=ii,!,ii:i:::i_i:iiii:::i:i! iiii!:_i¸!!:i:_::i:::i:i::!i:i::i:::!::¸¸:¸::¸:¸¸
CENTER
WORKPIECE
LEFT OFCENTER)
BE HAZAR
The table may be titted' for beveled work,
i
maintenance
WARNING: I FOR YOUR OWN SAFETY, TURN
SWITCH :::"OFF,: AND REMOVE PLUG FROM
POWER SOURCE:OUTLET BEFORE ADJUST,
ING,: MAINTAINING,:: OR LUBRICATING YOUR
BEL_T,AND DISC SANDER: ....
if:power cord is worn or cut, or damaged in any
WRY;_have;itlreplaced immed iately.
any dust
BLACK | BLACK JUMPER POWER CORD
WHITEs_ "_
,_ WHITE (/GREEN -
A:-coat-of automobile-type wax ::applied to::the
Wbrktai_ie will rhake it a: littie:easier to: feed the
work:while: finishing,
: = -
Do'i::noi!apply wax to: the abrasive belt table
because the belt could pick: up the wax and
deposit it on:the pulleys, causingthe belt to stip.
WiRiNG DIAGRAM
LUBRICATION
The BALL BEARINGS in this machine are packed
with grease at the factory. They require no
further lubrication.
18