Creality CR-10 Series Guide Book

7
1. Preheat
Method 1
Method 2
2.Feeding
Tip：How to Replace the Filament？
1、Cutting filament near the Extruder and slowly feed
new filament until they are fed into the new filament.
2、Preheating the nozzle and withdraw the filament
quickly and feed the new filament.

Press and hold the extruder lever then insert
the1.75mm filament through the small hole of the
extruder. Continue feeding until you see filament
come out the nozzle.
6.Loading Filament

Creality CR-10 Series Specifications

General

Build Volume	300 x 300 x 400 mm
Layer Resolution	0.1-0.4 mm
Filament Diameter	1.75 mm
Connectivity	SD Card, USB
Bed Temperature	Up to 100°C
Power Supply	110V/220V, 360W
Nozzle Diameter	0.4 mm (can be replaced with other sizes)
Supported Materials	PLA, ABS, PETG, TPU
Display	LCD
Frame Structure	Aluminum frame