8
1 2
34
1. Prepare →Auto Home. Wait for the nozzle to move to the
left/front of the platform.
2. Prepare→Disable Steppers(Close stepper drive，release motor)
3. Move the nozzle the front/left leveling screw and adjust the
platform height by turning the knob underneath. Use a piece of
A4 paper (standard printer paper) to assist with the adjustment,
making sure that the nozzle lightly scratches the paper.
4. Complete the adjustment of the screw on all 4 corners.
5. Repeat above steps 1-2 times if necessary.
7.Bed Levelling
To Next Page
Loading...
