1 2
5
3 4
5
Bed Levelling
调平平台
1. Slightly tighten the four levelling nuts at the bottom of the platform before initial levelling.
2. Select “Settings" →“Level mode" , click on the number ②.
3. Adjust the platform height by turning the knob underneath.Use a adjustment,making sure that the nozzle lightly presses on the paper.
4. Complete the adjustment on all 4 corners.
5. Click the number ① to test the platform height in the middle.
6. Repeat above steps one or two times if necessary.
1. 初次调平前，拧紧平台底部的四个调平螺母。
2. 选择设置→调平，点击数字②。
3. 拧动平台下面的旋钮来调整平台高度，调节打印平台喷嘴使二者处于刚好贴合状态，间距
约0.05mm,我们可以利用一张A4纸辅助调平,使喷嘴刚好能在A4纸上产生划痕。
4. 完成所有4个角的螺钉调整。
5. 点击①号，测试平台中间间隙是否合适。
6. 如有必要可重复，上述步骤1-2次。
To Next Page
Loading...
Need help?
General
