4. Operation and Use
15
The nozzle is too far away from the platform, so the filaments can not adhere to the platform.
The nozzle is too close to the platform, leading to insuficient filament extrusion, even scraping the platform.
Filaments are extruded evenly, just sticking on the platform.
For levelling effect, please refer to the operation and try to maintain a distance of approximately 0.1 mm between the printing platform and the nozzle.
If the first layer of printing effect is overpressure or does not stick to the platform, you need to use the knob to select the setting, adjust the Z axis
compensation, so that the printing platform and the nozzle fit as much as possible, and click OK to start printing.
60
60
60
60
60
To Next Page
Loading...
