EasyManuals Logo

Creality Ender-3 V3 SE User Manual

Creality Ender-3 V3 SE
26 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
3. Assembly Procedure
04
3.2 Display Screen
① Put the display screen on the right side of the bottom assembly, align the screw holes and secure with M4*10 screws, then connect the display wiring;
①
Tip：The card slot on the left side
of the display screen is only used
for inserting a card to upgrade the
screen firmware.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Creality Ender-3 V3 SE and is the answer not in the manual?

Creality Ender-3 V3 SE Specifications

General IconGeneral
Build Volume220 x 220 x 250 mm
Layer Resolution0.1 - 0.4 mm
Filament Diameter1.75 mm
Nozzle Diameter0.4 mm
Supported MaterialsPLA, PETG, TPU
Bed TemperatureUp to 100°C
Nozzle TemperatureUp to 260°C
Extruder TypeDirect Drive
Power Supply350W
Print Speed250 mm/s
ConnectivityUSB, SD Card
Bed LevelingAutomatic

Related product manuals