Need help?Do you have a question about the Creality Ender-3 V3 SE and is the answer not in the manual?
General| Build Volume | 220 x 220 x 250 mm |
|---|---|
| Layer Resolution | 0.1 - 0.4 mm |
| Filament Diameter | 1.75 mm |
| Nozzle Diameter | 0.4 mm |
| Supported Materials | PLA, PETG, TPU |
| Bed Temperature | Up to 100°C |
| Nozzle Temperature | Up to 260°C |
| Extruder Type | Direct Drive |
| Power Supply | 350W |
| Print Speed | 250 mm/s |
| Connectivity | USB, SD Card |
| Bed Leveling | Automatic |
To Next Page