EasyManuals Logo

Creality K1 Max User Manual

Creality K1 Max
31 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
FCC Caution:
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause undesired operation.
IMPORTANT NOTE:
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator& your body.
FCC Statement

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Creality K1 Max and is the answer not in the manual?

Creality K1 Max Specifications

General IconGeneral
Build Volume300 x 300 x 300 mm
Nozzle Diameter0.4 mm (default)
Filament Diameter1.75 mm
ConnectivityUSB, Wi-Fi, Ethernet
Bed LevelingAutomatic
Print TechnologyFDM (Fused Deposition Modeling)
Nozzle Temperature (Max)300°C
Bed Temperature (Max)120°C
Acceleration20000 mm/s²
Chamber Temperature (Max)60°C
Power SupplyAC 100-240V, 50/60Hz
Printing Speed600 mm/s
Supported FilamentsPLA, ABS, PETG, TPU
TouchscreenYes

Related product manuals