49
L510023-07
Type Information
To Prevent
Processing Delay
Pre-Delivery Checklist
Check for Bulletins
Engine Oil: Check
Drive Lube: Check All Fuel Lines:
Confi rm No Leaks
All Water Lines:
Confi rm No Leaks
Battery Rating, Charge, and Level:
Check
Control Adjustments:
Confi rm Proper Operation
All Drain Plugs: Confi rm
Proper Installation
Belt and Pulley: Inspect
for Damage
Gauges: Check for
Proper Operation
Record Propeller Size, Rotation and WOT - Port
WOT RPM_________Diameter_________ Pitch_________Rotation__________
Trouble Codes Checked
Trouble Codes Cleared
Dealer Reviewed Warranty
with Owner
Electrical Wiring: Check
for Proper Installation
All Oil Lines:
Confi rm No Leaks
Record Propeller Size, Rotation and WOT - Stbd
WOT RPM_________Diameter_________ Pitch_________Rotation__________
Starboard -
Record Fuel Pressure, WOT ______
Port -
Record Fuel Pressure, WOT ______
NOTICE: The following pages contain detailed steps in order to successfully perform the “Crusader
Pre-Delivery Inspection Procedure.” These steps should be read carefully and completely prior to
performing the inspection.
DELIVERY PREPARATION
NOTICE: Before starting the pre-delivery, read “General
Information” and “Installation Requirements” completely.
Test Running the Engine
IMPORTANT: If the engine is to be tested on land,
water must be supplied to the seawater pickup
pump. DO NOT run engine above 1500 RPM.
WARNING
If the engine is to be tested on land, propeller must
be removed.
To Next Page
Loading...
Need help?
General
