58
L510023-07
9. Lay-Up Engine (OPTIONAL)
Check the compliance box.
10. Complete the Pre-Delivery Checklist
Obtain the Crusader Warranty Registration Form that came with the engine.
Using the data obtained and recorded on the Pre-Delivery Inspection Procedure
complete the following blocks on the Warranty Registration Form:
Complete the Pre-Delivery Checklist by checking each box and fi ling in the
required data to signal compliance.
Engine Model No. (Port and Starboard)
Engine Serial No. (Port and Starboard)
Transmission Serial No. (Port and Starboard)
Check for Bulletins
Engine Oil: Check
Drive Lube: Check
Battery Rating, Charge, and Level: Check
Control Adjustments: Confi rm Proper Operation
Gauges: Check for Proper Operation
Record Propeller Size, Rotation, and WOT:
Port: WOT RPM Diameter Pitch Rotation
Stbd: WOT RPM Diameter Pitch Rotation
Record Fuel Pressure:
Port: WOT
Stbd: WOT
Belt and Pulley: Inspect for Damage
All Drain Plugs: Confi rm Proper Installation
All Fuel Lines: Confi rm No Leaks
All Oil Lines: Confi rm No Leaks
All Water Lines: Confi rm No Leaks
Electrical Wiring: Check for Proper Installation
Trouble Codes Checked / Trouble Codes Cleared
Your Diacom recording and these Pre-Delivery procedure sheets can be
archived either by engine serial number, owner’s name, or both for future
reference by the technician.
PORT STBD
CAUTION
If the new engine is test run and actual customer usage is not anticipated with
a seven-day period, the engine must be put back into a preserved state by
fogging the cylinders with rust-preventive oil. See the “Owner’s Operation and
Maintenance Manual.”
CAUTION
If the engine will not be used for an extended period of time, or will be exposed
to freezing temperatures, drain the water from the cooling system, as explained
in the “Owner’s Operation and Maintenance Manual.” Water MUST BE drained
to prevent corrosion and freeze damage to the engine.
To Next Page
Loading...
