11. Menu System Commands
(for DGPS MAX only)
The menu system is operated by a processor on-board the SLX within the
DGPS MAX. The menu system responds to a selection of specific NMEA
messages. In order to communicate with the processor running the menu
system, a virtual connection must first be established using the $JCONN,AB
command, issued through the MAIN port of the DGPS MAX.
The following table provides a brief description of the commands supported
by this processor for control of the menu system setup and operation.
Table 11-1 Menu System Commands
Message Description
$PCSI,HELP Sending this command returns the available commands and
queries for menu operations
$PCSI,BAUD This command allows you to change the baud rates
$PCSI,STATUS This command is not supported and is present for
debugging purposes only
$PCSI,SETUP,SET You may use this command to change the menu system
setup of the DGPS MAX
$PCSI,SETUP,SHOW This command is used to display the current menu system
setup of the DGPS MAX
$PCSI,SETUP,SAVE Sending this command will save the current menu system
setup
$PCSI,SETUP,READ This command is used to verify the integrity of the menu
system setup saved in memory
$PCSI,SETUP,RESET Use this command to reset the menu system configuration
$PCSI,SETUP,INTRO This command allows you to modify the introduction screen
displayed upon power-up
$PCSI,SETUP,MUX This command is not supported
The following subsections provide detailed information relating to the use of
each command.
To Next Page
Loading...
Need help?
General
