Programming Manual 56
7.1 RTCM Output ($JASC,BEAC,r)
This command allows you to remotely instruct the receiver to output
beacon RTCM data from the receiver, when operating in beacon mode.
This command has the following structure:
$JASC,BEAC,r
Where r is either 0 or 1 indicating OFF or ON, respectively.
The receiver will reply with the following response:
$>
7.2 Tune Command ($GPMSK)
There are three main derivatives of this command that affects the method of
SBX tuning, and each are described in the following sections.
7.2.1 Full Manual Tune Command ($GPMSK)
This command instructs the receiver’s internal beacon receiver to tune to a
specified frequency and MSK Rate. It has the following form:
$GPMSK,fff.f,M,ddd,M,n<CR><LF>
To Next Page
Loading...
