EasyManuals Logo

CSI Wireless Vector Sensor Programming Manual

CSI Wireless Vector Sensor
136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #56 background imageLoading...
Page #56 background image
Programming Manual 38
$JAGE,age<CR><LF>
Where maximum differential age timeout variable, ‘age’, may be a value from
6 to 8100 seconds.
The receiver will reply with the following response.
$>
4.4 $JOFF
This command allows you to turn off all data messages being output through
the current or other port, including any binary messages.
This command has the following definition.
$JOFF[,OTHER]<CR><LF>
When the ‘,OTHER’ data field is specified (without the square brackets), this
command will turn on the four NMEA messages on the other port.
There are no variable data fields for this message. The receiver will reply
with the following response.
$>
4.5 $JMASK
This command allows you to change the elevation cutoff mask angle for the
GPS engine. Any satellites below this mask angle will be ignored, even if
available. The default angle is 5 degrees, as satellites available below this
angle will have significant tropospheric refraction errors.
This message has the following format.

Table of Contents

Other manuals for CSI Wireless Vector Sensor

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CSI Wireless Vector Sensor and is the answer not in the manual?

CSI Wireless Vector Sensor Specifications

General IconGeneral
BrandCSI Wireless
ModelVector Sensor
CategoryReceiver
LanguageEnglish

Related product manuals