2.10 RD1 Data Message
The RD1 Data message contains a variety of information, has the following
format:
$RD1,s,w,f.f,l,ber,agc,dds,dop,dsp,arm,diff,nav<CR><LF>
Table 2-11 summarizes the contents of this message.
Table 2-11 RD1 Data Message Defined
Field Description
s GPS seconds
w GPS week
f.f Current frequency (MHz)
l Lock Indicator (1 = lock, 0 = no lock)
ber BER
agc AGC
dds DDS in Hz
dop Doppler in Hz
dsp DSP status
arm ARM status
diff Differential status
nav Navigation condition
*cc Checksum
<CR><LF> Carriage return and line feed
2.11 $PCSI,1 Beacon Status Message
This message contains a variety of information relating to the status of a CSI
Wireless SBX engine inside the receivers with beacon capability. The
$PCSI,1 output message from the SBX beacon module is intelligently routed
through the receiver to the port from which the $PCSI,1 message was
requested.
To Next Page
Loading...
