$>PCSI,Setup,RTCMRate,9600
$>PCSI,Setup,LLFormat,DM
$>PCSI,Setup,HeightFormat,Meters
$>PCSI,Setup,SpeedFormat,KMPH
$>PCSI,Setup,UTCOffset,0
$>PCSI,Setup,DiffSource,LBAND
$>PCSI,Setup,FiveHertz,Off
$>PCSI,Setup,TopIntro,CSI Wireless Inc
$>PCSI,Setup,BottomIntro, DGPS MAX
The following table provides detail on the optional states of each line in the
output above:
Field Purpose Options Description
dms Lat/Long Format DD Degrees ( dd.ddddd )
DMS Degrees, Minutes, Seconds ( dd mm ss.ss )
DM Degress, Minutes ( dd mm.mmm )
ft Altitude Format FEET Feet
METERS Meters
spd Speed Format KMPH Kilometers per Hour
MPH Miles per Hour
KNOTS Knots per Hour
utc UTC offset -12<x<12 UTC Offset
diff Differential Source NONE Autonomous Mode
BEACON SBX-2, Beacon Mode
LBAND SLX-2, OmniStar Mode
WAAS SLX-2, WAAS Mode
EXTERNAL External RTCM, Port A Mode
hz GPS Update Rate 5 GGA and VTG Information received at 5 Hz.
1 GGA and VTG Information received at 1 Hz
.
11.7 $PCSI,SETUP,SAVE
To save the current setup parameters in memory for the DGPS MAX to use
on any subsequent startups, use the following command to save the setup:
$PCSI,SETUP,SAVE<CR><LF>
To Next Page
Loading...
Need help?
General
