Where:
Field Purpose Options Description
n Wizard Number 1 – 5 Wizard Number, 1 to 5
gg GGA rate 0, 1, 5, 0.2 Valid rate for GGA
gl GLL rate 0, 1, 5, 0.2 Valid rate for GLL
gs GSA rate 0, 1, 5, 0.2 Valid rate for GSA
st GST rate 0, 1, 5, 0.2 Valid rate for GST
sv GSV rate 0, 1, 5, 0.2 Valid rate for GSV
rm RMC rate 0, 1, 5, 0.2 Valid rate for RMC
rr RRE rate 0, 1, 5, 0.2 Valid rate for RRE
vt VTG rate 0, 1, 5, 0.2 Valid rate for VTG
zd ZDA rate 0, 1, 5, 0.2 Valid rate for ZDA
b95 Bin 95 rate 0, 1, 5, 0.2 Valid rate for Bin 95
b96 Bin 96 rate 0, 1, 5, 0.2 Valid rate for Bin 96
rtcm RTCM Enable ON/OFF RTCM Enable
12.4 $PCSI,WIZARD,SHOW
To see the setup for all Wizard Entries, issue the following command:
$PCSI,WIZARD,SHOW
The MAX will respond by displaying the following message:
$>PCSI,WIZARD,SETUP,1,WAAS,9600,9600,WAAS,10,360,1551489,1200,313.0,1
$>PCSI,WIZARD,RATES,1,1,0,0,0,1,0,0,0,0,0,0,0
$>PCSI,WIZARD,SETUP,2,LBAND,9600,9600,LBAND-A,10,360,1551489,1200,313.0,1
$>PCSI,WIZARD,RATES,2,1,0,0,0,0,0,0,0,0,0,0,0
$>PCSI,WIZARD,SETUP,3,AUTO,9600,9600,NONE,10,360,1575420,1200,313.0,1
$>PCSI,WIZARD,RATES,3,5,0,0,0,0,0,0,0,0,0,0,0
$>PCSI,WIZARD,SETUP,4,BEACON 310,9600,9600,BEACON-A,10,360,1551489,1200,313.0,1
$>PCSI,WIZARD,RATES,4,1,0,0,0,0,0,0,0,1,0,0,1
$>PCSI,WIZARD,SETUP,5,EXTERNAL,9600,9600,EXTERNAL,10,7860,1575420,1200,313.0,1
$>PCSI,WIZARD,RATES,5,1,0,0,0,1,0,0,1,0,0,0,0
To Next Page
Loading...
Need help?
General
