This message is summarized in the following table
Data field Description
Opt This field indicates a WET or DRY subscription
Source RTCM source ID or ALL if VBS
AccrReduction 0 is most accurate
StartDate Subscription start date
EndDate Subscription end date
HourGlass Seconds of metered time
Extention Time Seconds of extension
LinkVector hexadecimal mask of links
SoftwareVersion This item shows the OmniSTAR library version
An example of this response follows:
$>JOMS,DRY,ALL,VBS,0,01/06/2000,01/06/2001,0,0,1E00,1.43
6.4 $JOMR
This command displays raw OmniSTAR region information and has the
following structure:
$JOMR
The receiver will respond with the following messages:
$JOMR,1,latitude1,longitude1,radius1<CR><LF>
$JOMR,2,latitude2,longitude2,radius2<CR><LF>
$JOMR,3,latitude3,longitude3,radius3<CR><LF>
$JOMR,4,latitude4,longitude4,radius4<CR><LF>
$JOMR,5,latitude5,longitude5,radius5<CR><LF>
Where latitude and longitude are expressed in radians and the radius is in
meters.
To Next Page
Loading...
Need help?
General
