EasyManuals Logo

CSI Wireless Vector Sensor Programming Manual

CSI Wireless Vector Sensor
136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #120 background imageLoading...
Page #120 background image
Programming Manual 102
11.1 Virtual Circuit ($JCONN,AB)
The commands described in this section require the issue of the virtual
circuit command, $JCONN,AB discussed in Chapter 3. This command
establishes a direct connection to the microprocessor that operates the
menu system of the DGPS MAX receiver.
11.2 $PCSI,HELP
This command provides a listing of the available commands for use and has
the following definition:
$PCSI,HELP<CR><LF>
The DGPS MAX will respond with the following data output:
$>PCSI,Version,P022-x.xxx
$>PCSI,HELP -Help message
$>PCSI,BAUD, -Baud Rate
$>PCSI,SETUP,SET, -LL,HGT,SPD,UTC,SRC,RT
$>PCSI,SETUP,SHOW -Shows Setup
$>PCSI,SETUP,MUX -Enable/Disable Communication Mux
$>PCSI,STATUS,CS -Checksum Error Report
Where ‘x.xxx’ is the current menu system version number.
11.3 $PCSI,BAUD
The $PCSI,BAUD command is used to change the DGPS MAX’s baud rate
and has the following structure:
$PCSI,BAUD,baud<CR><LF>
Where ‘baud’ is the following valid baud rates.

Table of Contents

Other manuals for CSI Wireless Vector Sensor

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CSI Wireless Vector Sensor and is the answer not in the manual?

CSI Wireless Vector Sensor Specifications

General IconGeneral
BrandCSI Wireless
ModelVector Sensor
CategoryReceiver
LanguageEnglish

Related product manuals