Brakes and Drive System
37
NOTE: Apply Loctite #271 or an equivalent thread-locker
to the threaded section of the drive axle. Tighten
the nut that secures the drive gear to a torque of
42 - 50 ft lbs. (56 - 68 Nm).
NOTE: Fill the drop axle with 10.5 ounces of 737-0300A
Durina
TM
grease.
NOTE: The drop axle has four different length screws
securing the housings together.
Figure 3.37 shows
were the different screws go.
NOTE: Tighten the screws to a torque of 90-120 in lbs.
(10 - 14 Nm).
21. Test drive the mower in a safe area before returning
it to service.
A = 1/4-20 x 1.00”
B = 1/4-20 x 1.25”
C = 1/4-20 x 1.50”
D = 1/4-20 x 2.00”
A
C
C
B
B
D
C
D
To Next Page
Loading...
