Cub Cadet RZT-S Zero Shop Manual

Assembly Instruction Manual
A1
IMPORTANT: The RZT-S Zero must be assembled by the Cub Cadet dealer prior to delivery to the customer.
The Underwriters Laboratories certification for these mowers does not allow for the consumer
to access the batteries or any of the wiring. This Manual is intended to provide service dealers
with the instructions to assemble a RZT-S Zero mower.
1. Uncrate the mower:
1a. Remove the upper crating material from the
shipping pallet.
1b. Remove the plastic wrap and cut any bands or
tie straps securing the tractor to the pallet.
1c. Raise the deck to its highest position.
1d. Disengage the parking brake.
1e. Pull out the drive release rods. The Z- bends
in the rods will hook into slots in the frame
See Figure 1.
1f. Carefully roll the tractor off the shipping pallet.
1g. Release the drive release rods after rolling the
tractor off the pallet.
NOTE: The steering column is tilted all the way
back for shipping.
2. Remove the steering wheel.
3. Remove the discharge chute deflector.
Figure 1
Drive release rods
Figure 2
ASSEMBLY INSTRUCTION MANUAL

Cub Cadet RZT-S Zero Specifications

General

Brand	Cub Cadet
Model	RZT-S Zero
Category	Lawn Mower
Language	English