33
PRINTING PREPARATION
1. Remove glue from the foam and remove cap.
2. Remove print pad from the Cube; paint a thin coat of glue on the entire print pad until the glue is evenly distributed (do
not over apply). Replace glue cap after use.
3. Place print pad on the print pad platform.
NOTE: The Magic Cube Glue will have to be applied on the print pad every time you start a new creation.
Caution: Do not use any other type of glue other than Magic Cube Glue. Doing so can damage
your print tip and the print pad.
19
To Next Page
Loading...