Cube 3d printer - Maintaining Your Cube; Cleaning the Exterior; Cleaning the Print Pad; Cleaning the Print Tip

42
MAINTAINING YOUR CUBE
23
Cleaning the Exterior
 Clean the Cube’s exterior with a lint free cloth and water. Dampen the cloth with water and wipe the
outer surfaces of any debris that is visible.
Cleaning the Print Pad
 6XEPHUJHSULQWSDGLQDFRQWDLQHU¿OOHGZLWKZDUPFLW\WDSZDWHU3OHDVHGRQRWXVHZHOOZDWHULWFRQWDLQV
FHUWDLQPLQHUDOVWKDWPD\PDNH\RXUFUHDWLRQGLI¿FXOWWRUHPRYHIURPWKHSULQWSDG
 Rinse pad under tap water and dry using a lint free wipe.
 It may be necessary to use the plastic scraper to remove the glue while rinsing the print pad.
Cleaning the Print Tip
WARNING – PRINT TIP AND PRINT
PAD BECOMES EXTREMELY HOT
DURING SET-UP AND OPERATION.
DO NOT TOUCH NOZZLE AND PRINT
PAD.
 Using the small pliers, pull away any plastic debris away from the nozzle tip.
 If the debris is stubborn, the nozzle may need to be heated to make the debris soft
enough to remove.