Cube 3d printer - Printing from the USB Drive

37
 2QWKH&XEHWRXFKVFUHHQ¿QJHUWDSFKHFNER[WRVWDUWWKHEXLOG¿OHRUWDSWKHX box to cancel.
3. The Cube will begin a ten minute heating process. During the heating process, the print tip and the print pad will reach the
temperatures that have been preset by the manufacturer. Once these temperatures are reached, your creation will begin to
print.
Tap here
WARNING – PRINT TIP AND PRINT PAD BECOMES EXTREMELY HOT DURING SET-UP AND OPERATION.
DO NOT TOUCH NOZZLE AND PRINT PAD.
Do not change cartridge material during printing; doing so may damage the Cube.
NOTE: During printing operation, please do not place a cover over your Cube. The Cube generates heat during
printing and if covered, it can cause damage to the Cube.
Printing From the USB Drive
 ,I\RXDUHXVLQJ\RXU86%GULYHWRGRZQORDG\RXU&XEH¿OHSOHDVHLQVWDOOWKH86%GULYHLQWRWKH86%SRUWRQ\RXUFRPSXWHU
2SHQWKH¿OHIROGHUZKHUH\RXU&XEH¿OHLVORFDWHGDQGVDYHLWRQWKH86%GULYH5HPRYH86%GULYHDQGLQVWDOOLWLQWRWKH
Cube’s USB port.