8.930-369.0 • 2848 • Rev. 4/13a
13
PARTS WASHER
OPERATOR’S MANUAL
SECTION 2: INSTALLATION
Step 6:
Turn the wash cycle timer to 2 hours for the first time,
and allow the machine to complete the cycle to thor-
oughly dissolve the detergent into the water.
Step 7: Deluxe Kit (Optional)
After the machine stops, remove the right sump cover
and transfer approximately two gallons of wash solution
into the detail sump using a small submersible pump
or a suitable container.
WARNING: Hot cleaning solution could cause
serious injury. Always wear rubber gloves and
approved eye protection when handling hot
cleaning solution.
Step 8:
Replace all sump covers.
When the machine stops, and after the wash water
reaches operating temperature, it is ready for use.
Refer to Section 3: Operation for complete operating
instructions.
To Next Page
Loading...
