© 2012 Cummins-Allison Corp.
Printed Reports
Port 1 or 2 on the back of the JetCount (find the connectors in the lower right corner when facing
the front of the machine) is designed for the connection of a printer. The printer can be enabled
or disabled during the setup process.
When the ADD function is disabled, print reports are sent to the printer automatically. They are
sent when the machine is in “time-out” and the stacker has been cleared of documents. When the
ADD function is enabled, print reports are sent to the printer once totals are cleared.
Each report generated by JetCount features a number immediately below the name of the report.
The first five digits in this number indicate the sequence of this report among all reports sent to
the printer. It will increase by one digit each time a report is sent and will reset to zero each time
the Day Total is cleared. The next four digits indicate Batch number.
Setup Report
The Setup Report is only generated in Setup Fields, when Port 1 or Port 2 is set to PRINTER. In
Setup, the following screen appears:
Press KEY 3 to generate the following report:
Strap Density Denomination
Count Speed
BATCH REPORT
00001-0001-000
DENOM UNIT VALUE
$1 60 $ 60
$5 29 $ 145
$10 8 $ 80
BATCH 97 $ 285
TOTAL
To Next Page
Loading...
