JetCount
®
Currency Counter
All Models
How to Use Count Mode
Count mode counts any currency, food stamps, etc., that fit the hopper size. In this mode, JetCount is
only counting “slips of paper” (no currency scanning is taking place). Therefore, the COUNT total
reflects the number of pieces.
When the ADD function is ON, JetCount will accumulate totals until RESET is pressed to clear count
totals. When the ADD function is OFF, the machine will clear totals each time the stacker is emptied.
Processing Documents
By default the display shows:
Strap Density Denomination
Count Speed
Make sure that all notes are stacked neatly. Place the new stack of notes in the hopper. The
machine will begin counting.
JetCount may stop if one of the following conditions occurs: JAM, CHAIN, DOUBLE,
SUSPECT DOCUMENT and STRAP LIMIT. (See Stopping Conditions and Recovery Steps for
instructions on clearing the condition indicated on the screen.)
JetCount will time out and stop automatically within two seconds when all documents have
been run.
Machine is auto-start capable. Feed rollers in hopper rotate inward.
Entanglement and drawing-in hazard.
Do not operate with exposed long hair, neckties, jewelry or loose clothing.
To Next Page
Loading...