Curtis 1244-64 series User Manual

24
Curtis 1244 Manual, Rev. E
3 — PROGRAMMABLE PARAMETERS
e programmable parameters are described in the following order. ey
are listed in the text by the abbreviated names that are displayed by the pro-
grammer. Not all of these parameters are displayed on all controllers; the list
for any given controller depends on its specifications.
ere are additional parameters that can only be configured at the factory.
e manufacturer can specify how these parameters will be configured, but they
are not programmable using the programmer. See Section 4: OEM Specified,
Factory Set Parameters.
Acceleration Parameters
Acceleration Rate, M1–M4
Braking Rate, M1–M4
Deceleration Rate
Quick Start
Taper Rate
Speed Parameters
Maximum Speed, M1–M4
Creep Speed, M1–M4
Regen Speed
rottle Parameters
Control Mode
rottle Type
rottle Deadband
rottle Maximum
rottle Map, M1–M4
rottle Braking Percent, M1–M4
Current Limit Parameters
Drive Current Limit, M1–M4
Braking Current Limit, M1–M4
Minimum Field Current Limit
Maximum Field Current Limit
Restraint
Emergency Reverse Current Limit
Current Ratio

Curtis 1244-64 series Specifications

General

Brand	Curtis
Model	1244-64 series
Category	Controller
Language	English