Curtiss-Wright | Tritex II AC 90, 115 Rev. X PN39892 7/12/22
SAFETY CONSIDERATIONS
Warnings and Cautions
As with any electro-mechanical device, safety must be considered
during the installation and operation of your Tritex II Series actuator.
Throughout this manual, you will see paragraphs marked with CAUTION
and WARNING signs as shown below:
“WARNING” indicates the information following is
essential to avoiding a safety hazard.
“CAUTION” indicates the information following is
necessary for avoiding a risk of damage to the product or
other equipment.
General
Failure to follow safe installation guidelines can cause
death or serious injury. The voltages used in the product
can cause severe electric shock and/or burns and could be lethal.
Extreme care is necessary at all times when working with or adjacent to
the product. The installation must comply with all relevant safety
legislation in the country of use. The forces created by actuator could be
lethal or cause severe injury if proper protection is not provided to keep
personnel away from moving components.
System Design and safety for personnel
The actuator is intended as a component for professional
incorporation into complete equipment or a system. If
installed incorrectly, the actuator may present a safety hazard. The
actuator uses high voltages and currents, carries a high level of stored
electrical energy, and is used to control equipment which can cause
injury. Close attention is required to the electrical installation and the
system design to avoid hazards either in normal operation or in the event
of equipment malfunction. System design, installation, commissioning
To Next Page
Loading...