PRINT MODE
Normal
D
= enables printing in normal writing way
Reverse = enables printing rotated 180 degrees
AUTOFEED Setting of the Carriage Return character:
CR disabled
D
= Carriage Return disabled
CR enabled = Carriage Return enabled
CHARS / INCH Font selection:
A = 17 cpi, B = 22 cpi
D
A = 13 cpi, B = 17 cpi
NOTE:
CPI = Characters Per Inch
CODE TABLE [num]
setting of two digits for the tens and the units:
CODE TABLE [num x 10]
Setting the digit for tens:
0
D
2 4
1 3 5
CODE TABLE [num x 1]
Setting the digit for units:
0
D
2 4 6 8
1 3 5 7 9
NOTE:
with this parameter.
The character tables set with this parameter are the same set with the command 0x1B 0x74 (refer to the
Commands Manual of the device).
FONT TYPE Setting of the font type:
International
D
= Enables the use of the 256 characters font tables
Chinese GB18030 = Enables the use of the chinese extended font GB18030-2000
NOTE: When the "INTERNATIONAL" font is enabled, you need to choose the character code table (parameter
“CODE TABLE”). When the Chinese or Korean fonts is enabled, the selection of the character code table
is suspended (parameter “CODE TABLE”).
SPEED / QUALITY Setting of printing speed and printing quality:
Normal
D
High Quality
35
To Next Page
Loading...
Need help?
General
