KPM180H (models with presenter)
Cutting line
Printing line Cutting line Printing line
A A
L
DH
PRINTED
AREA
PRINTING DIRECTION
A “Non-printable area” of 1 mm generated from:
“Distance between cutter/printing head”- “Value for the paper recovery after a cut”
where:
“Value for the paper recovery after a cut”= 19 mm
In CUSTOM/POS emulation use the command 0x1C 0xC1 to set the “Value for the paper recovery after a cut”
(see Commands Manual).
L Distance between an edge of the notch and the next one, called “Inter-notch distance”.
D Automatic feed for alignment at the next notch.
To use all the notches on paper, you must comply with the following equation:
The height of the printing area (H) can be increased to make no progress on alignment (D) but no further.
115
To Next Page
Loading...
