5.2 Setup report
and the description of device parameters see the following paragraphs.
DEVICE NAME and
FIRMWARE MODULES
RELEASE
PRINTING HEAD
STATUS
DEVICE
STATUS
PRINTER SETTINGS
1
----------------------------------------------------------------------------
PRINTHEAD WORKING GOOD!
PRINTER TYPE ....................................<device model>
PRINTING HEAD TYPE ........................<head model>
INTERFACE ..........................................RS232
PROGRAM MEMORY TEST.................OK
DYNAMIC RAM TEST...........................OK
EXTERNAL MEMORY TEST ................OK
CUTTER TEST......................................OK
HEAD VOLTAGE [V] = 23,37
HEAD TEMPERATURE [°C] = 25
CUT COUNTER = 1
Printer Emulation............................. : CUSTOM/POS
RS232 Baud Rate ........................... : 115200 bps
RS232 Data Length......................... : 8 bits/chr
RS232 Parity ................................... : None
RS232 Handshaking ....................... : Hardware
Busy Condition ................................ : RxFull
USB Mass Storage.......................... : Disabled
USB Address Number ..................... : 0
USB Virtual COM............................. : Disabled
Print Mode ....................................... : Normal
Autofeed .......................................... : CR Disabled
Code Table [num] ............................ : 0
Chinese Font .................................. : Disabled
Chars / inch ..................................... : A=15 B=20 cpi
Speed / Quality................................ : Normal
Print Width....................................... : 80 mm
Paper Threshold .............................. : 40%
Notch/B.Mark Position..................... : Bottom
Notch/B.Mark Threshold.................. : 40%
Notch Distance [mm] ....................... : +00.0
Notch/B.Mark Min.Width.................. : 0 mm
Ticket Locking.................................. : Disabled
Ticket Management ......................... : Disabled
PrintHead Test PowerOn................. : Disabled
Casing Type..................................... : Plastic
Print Density.................................... : 0%
[ LF ] enter Setup
[ FF ] skip Setup
<device name>
SCODE. <code>
DCODE. <code>
FCODE. <code>
KEYS FUNCTIONS
PRINTER
PARAMETERS
60
To Next Page
Loading...
