12.5 Setup
-
some sections (indicated in square brackets).
The available values for every parameter, are listed after the parameter name. The value marked with the symbol ‘ * ’ is the
default one. To modify printer’s parameters, change the numeric value after the name of parameters. To set the parameter
to the default value, change the numeric value with the symbol D.
[PRINT]
Printer Emulation 0*, 1 0 = CUSTOM/POS
1 = SVELTA
Print Mode 0*, 1 0 = Normal
1 = Reverse
Autofeed 0*, 1 0 = CR disabled
1 = CR enable
Chars / inch 0, 1*, 2 0 = A=11 B=15 cpi
1 = A=15 B=20 cpi
2 = A=20 B=15 cpi
Code Table [num] 0
Chinese font 0*, 1 0 = Disabled
1 = Enabled
Speed / Quality 0, 1*, 2 0 = High Quality
1 = Normal
2 = High Speed
Paper Width 0, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10,
11, 12, 13, 14, 15, 16, 17, 18,
19, 20, 21, 22, 23, 24, 25, 26,
27, 28, 29, 30, 31*
0 = 18 mm
1 = 20 mm
2 = 22 mm
3 = 24 mm
4 = 26 mm
5 = 28 mm
6 = 30 mm
7 = 32 mm
8 = 34 mm
9 = 36 mm
10 = 38 mm
11 = 40 mm
12 = 42 mm
13 = 44 mm
14 = 46 mm
15 = 48 mm
16 = 50 mm
17 = 52 mm
18 = 54 mm
19 = 56 mm
20 = 58 mm
21 = 60 mm
22 = 62 mm
23 = 64 mm
24 = 66 mm
25 = 68 mm
26 = 70 mm
27 = 72 mm
28 = 74 mm
29 = 76 mm
30 = 78 mm
31 = 80 mm
Paper Threshold 0, 1*, 2, 3, 4, 5, 6 0 = 30 %
1 = 40 %
2 = 50 %
3 = 60 %
4 = 70 %
5 = 80 %
6 = 90 %
121
To Next Page
Loading...
