PROTOCOL STX Value of the start byte of protocol (up to three bytes, expressed in hexadecimal).
NOTES:
If '00' value is set, this parameter is disabled.
PROTOCOL ETX Value of the end byte of protocol (up to three bytes, expressed in hexadecimal).
NOTES:
This parameter, unlike the STX, can not be disabled.
PRINT MODE Printing mode:
Normal
D
= enables printing in normal writing way
Reverse = enables printing rotated 180 degrees
AFTER CUT
EJECTER TYPE
Management of the ejector device:
Presenter
D
= after the printing end, the device cuts the ticket and holds it between the
ejector rollers in a "cut & hold" mode waiting for the user withdrawal
Ejecter = after the printing end, the device cut the ticket and eject it
NOTES:
The "cut & hold" mode need to be enabled by protocol. Otherwise, the device performs an eject even if
Presenter value is set.
This parameter is valid only for KPM180H models with presenter.
SPEED / QUALITY Setting of printing speed and printing quality:
Normal
High Quality
High Speed
D
PAPER THRESHOLD Threshold value (in percent) for the recognition of the presence of paper by the paper
presence sensor:
30% 70%
40%
D
80%
50% 90%
60%
NOTCH/B.MARK
POSITION
Position of the alignment notch and choice of appropriate notch sensor:
Disabled = the notch alignment is not performed
Transparent
D
= the notch is detected by the bottom sensor and the top sensor placed in
front of (transparence)
64
To Next Page
Loading...
