NOTCH/B.MARK
THRESHOLD
Threshold value (in percent) for the recognition of the presence of notch by the notch
sensor:
30% 70%
40% 80%
50% 90%
60%
D
NOTE:
If the “Notch/B.Mark position” parameter is disabled, this parameter is not printed.
BARCODE ID 4
Code128 = sets the Code128 format
DataMatrix
D
= sets the DataMatrix format
NOTE:
The parameter is printed only with ATB or BTP emulation enabled.
VERTICAL SCALE [%] Adjust of the printing positions by adding the percentage value to the coordinates of ele-
ments (in the direction of the length of the ticket).
NOTE:
The parameter is printed only with ATB or BTP emulation enabled.
PRESENTER OFFSET [mm] Setting of the presentation distance of ticket in case of presentation mode enabled (paper
cut disabled).
NOTE:
The parameter is printed only with ATB or BTP emulation enabled.
ATB TICKET LENGTH
Auto
D
= at the paper autoload, the device automatically calculates the ticket
length by detecting two consecutive black marks and then recover
Auto No Recovery = at the paper autoload, the device automatically calculates the ticket
length by detecting two consecutive black marks. The ticket used
for detection is not recovered.
8" Fixed = the ticket length is set to 8"
7" 3/8 Fixed = the ticket length is set to 7" 3/8
NOTES:
The parameter is printed only with ATB emulation enabled.
SERVICE ALIGNMENT
TYPE
Edge
D
= the point for the notch alignment is the frontal edge of notch
Center = the point for the notch alignment is the center of notch
NOTES:
The parameter is printed only with SERVICE emulation enabled.
In ATB or BTP emulation, the point for the notch alignment is always set to the center of notch.
65
To Next Page
Loading...
Need help?
General
