EasyManuals Logo

Custom Audio Electronics VKP80II User Manual

Custom Audio Electronics VKP80II
76 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
5.4 Printer parameters
This printer allows the con guration of the parameters listed in the following table.
The parameters marked with the symbol
D
are the default values.
Settings remain active even after the printer has been turned off and they are stored in non-volatile memory.
RS232 BAUD RATE
Communication speed of the serial interface:
115200 19200
D
2400
57600 9600 1200
38400 4800
RS232 DATA LENGTH
Number of bit used for characters encoding:
7 bits/car
8 bits/car
D
RS232 PARITY
Bit for the parity control of the serial interface:
None
D
= parity bit omitted
Even = even value for parity bit
Odd = odd value for parity bit
RS232 HANDSHAKING
Handshaking:
XON/XOFF = software handshaking
Hardware
D
= hardware handshaking (CTS/RTS)
BUSY CONDITION
Activation mode for Busy signal:
RXFull
D
= Busy signal is activated when the buffer is full
OffLine/ RXFull = Busy signal is activated when the printer is both in OffLine status
and the buffer is full
NOTE: Parameter valid only with serial interface; using this parameter, it is possible to select whether
the Busy signal is activated when the printer is both in Off Line status and the buffer is full or only if the
reception buffer is full.
USB ADDRESS NUMBER
Numerical address code for the univocal identi cation of the USB device (in case of
more than a USB device connected with the same PC):
0
D
3 6 9
1 4 7
2 5 8
NOTE: This parameter is used to identify univocally the USB printer by a numerical address code, if on
the PC are connected two printers that are the same models.
USB STATUS MONITOR
Setting for the driver module Status Monitor:
Disabled
D
= Status Monitor disabled
Enabled = Status Monitor enabled
NOTE: The Status Monitor is an additional printing driver component that allows the printer status moni-
toring. It must be enabled only if the Status Monitor speci c driver was installed.
AUTOFEED
Setting of the Carriage Return character:
CR disabled
D
= Carriage Return disabled
CR enabled = Carriage Return enabled
5. CONFIGURATION
User Manual VKP80II 31

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Custom Audio Electronics VKP80II and is the answer not in the manual?

Custom Audio Electronics VKP80II Specifications

General IconGeneral
BrandCustom Audio Electronics
ModelVKP80II
CategoryPrinter
LanguageEnglish

Related product manuals