11.3 Setup
It is possible to confi gure the default parameters for printer setup by editing the “Setup.ini” fi le on the printer Flash Drive.
After editing printer’s parameter, simply save the “Setup.ini” fi le to make the modifi es activated.
The “Setup.ini” fi le is a confi guration fi le that contains all the confi gurable parameters listed in text format and divided
into some sections (indicated in square brackets). The available values for every parameter, are listed after the pa-
rameter name. The value marked with the symbol ‘ * ’ is the default one.
To modify printer’s parameters, change the numeric value after the name of parameters. To set the parameter to the
default value, change the numeric value with the symbol D.
The “Setup.ini” fi le permits the confi guration of the following parameters:
[PRINT]
PRINTER EMULATION 0*, 1 0 = SERVICE
1 = BTP
PRINT MODE
0*, 1 0 = Normal
1 = Reverse
SPEED / QUALITY
0*, 1, 2 0 = High Quality
1 = Normal
2 = High Speed
PAPER THRESHOLD
0, 1*, 2, 3, 4, 5, 6 0 = 30% 3 = 60% 6 = 90%
1 = 40% 4 = 70%
2 = 50% 5 = 80%
NOTCH/B.MARK
POSITION
0, 1, 2*, 3 0 = Disabled
1 = Bottom
2 = Transparence
3 = Top
NOTCH/B.MARK
THRESHOLD
0*, 1, 2, 3, 4, 5, 6, 7 0 = 20% 3 = 50% 6 = 80%
1 = 30% 4 = 60% 7 = 90%
2 = 40% 5 = 70%
BARCODE ID 4
0, 1* 0 = Code128
1 = DataMatrix
VERTICAL SCALE [%]
PRESENTER OFFSET [mm]
ALIGN TICKET
0*, 1, 2, 3 0 = Disabled
1 = Power On
2 = Autoload
3 = P.On/Load
RFID ENCODING
0*, 1 0 = AEA standard
1 = Custom01
NEAR PAPER END
0*, 1 0 = Disabled
1 = Enabled
[INTERFACE]
RS232 BAUD RATE
1, 2, 3, 4*, 5, 6, 7, 8 1 = 1200 4 = 9600 7 = 57600
2 = 2400 5 = 19200 8 = 115200
3 = 4800 6 = 38400
11. ADVANCED FUNCTIONS
106 KPM150H-AERO User manual
To Next Page
Loading...
