Custom Engineering KPM150H - Page 61

NOTCH/B.MARK
POSITION
Position of the alignment notch and choice of appropriate notch sensor:
Disabled = the notch alignment is not performed
Top = the notch position is detected by the upper sensor (refl ection)
Bottom = the notch position is detected by the lower mobile sensor (refl ection)
Transparence
D
= the notch position is detected by both the sensors (transparence)
NOTCH/B.MARK
THRESHOLD
Threshold value (in percent) for the recognition of the presence of notch by the notch
sensor:
20%
D
50% 80%
30% 60% 90%
40% 70%
NOTE: If the “Notch/B.Mark Position” parameter is disabled, this parameter is not printed.
USB VIRTUALCOM
Setting of the USB port as a virtual serial port:
Disabled
D
= virtual COM disabled
Enabled = virtual COM enabled
NOTE: To use this confi guration it is necessary to install an additional driver.
NEAR PAPER END
Setting of the near paper end detection:
Disabled
D
= detection disabled
Enabled = detection enabled
BARCODE ID 4
Setting of the barcode format associated with ID 4 (see AEA specifi cations):
Code128
D
= sets the Code128 format
DataMatrix = sets the DataMatrix format
5. CONFIGURATION
User manual KPM150H-AERO 61