Custom Engineering KPM150H - Firmware upgrade

6.4 Firmware upgrade
WARNING: BEFORE PROCEEDING WITH THE
UPGRADE PROCEDURE, SET THE “SERVICE”
VALUE FOR THE “EMULATION” PARAMETER (SEE
CHAPTER 5).
WARNING: During communication between PC/
printer for the fi rmware update it is strictly forbidden
to disconnect the communication cable or to remove
the power supply of the devices not to endanger the
proper functioning of the printer.
Note: Contact Customer Service to get the latest fi rm-
ware of the printer.
Note: Install on the PC used for printer upgrading the
UPGCEAERO software available in the download area
of the web site www.custom.biz.
UPDATE VIA SERIAL INTERFACE
Proceed as follows:
1. Write down the product code (14 digits) printed on the
product label (see par. 2.4).
2. Go to the web site www.custom.biz and download the
appropriate fi rmware release from the DOWNLOAD
area.
3. Print the SETUP report (see chapter 5).
4. Enter the SETUP procedure and set the “Service”
value for the “Emulation” parameter (see chapter 5).
5. Switch off the printer.
6. Connect the printer to the PC using a serial cable
(see par.3.2).
7. Switch ON the printer.
8. Start the software UPGCEAERO.
9. Select the update fi le .PSW location :
10. Select the serial communication port (e.g. COM1):
C:\KPM150H.PSW
11. Detecting and setting of the parameters necessary
for serial communication are performed automatically
and then updating begins.
12. After a few minutes a message on the screen warns
that the update is completed.
13. Print a new SETUP report to verify the new fi rmware
release (see chapter 5).
UPDATE VIA USB INTERFACE
WARNING: Only during the fi rmware update, the con-
nection between PC and printer must be direct, without
the use of wireless HUB.
WARNING: Only during the fi rmware update, do not
connect or disconnect other USB devices.
Note: For communication via USB you must install on
PC the printer driver available in the download area of
the web site www.custom.biz.
Proceed as follows:
1. Write down the product code (14 digits) printed on the
product label (see par. 2.4).
2. Go to the web site www.custom.biz and download the
appropriate fi rmware release from the DOWNLOAD
area.
3. Print the SETUP report (see chapter 5).
6. MAINTENANCE
78 KPM150H-AERO User manual