CYBEX 525T - Page 152

Remove end caps
1. Remove two screws securing right end cap using a Phillips screwdriver.
Qty.DescriptionItem
1Right end cap1
2Screws2
2. Repeat step for left end cap.
Remove top steps
1. Remove the five screw covers from the right top step using a flat head screwdriver.
Qty.DescriptionItem
5Screw cover1
5Screw2
5Screw cover base3
1Top step, right4
2. Remove the five screws and five screw cover bases securing the right top step using a Phillips
screwdriver.
3. Repeat steps for the left top step.
Loosen rear roller
Loosen the rear roller mounting bolts using a 3/4” Socket wrench.
Loosen front roller
Loosen the front roller mounting bolts using a 9/16” Socket wrench.
Remove drive belt
Remove the drive belt off of the drive motor pulley.
Page 152 of 199
Cybex 525T Treadmill Part Number