4. Tap Select Xmtr to select your transmitter type from the available choices. The display will only
show choices available under your transmitter type (900 MHz, 863 MHz or 806 MHz).
806 MHz System863 MHz System900 MHz System
"J1 806" Japan 14 channels"M 863" MYE"M 900" MYE
"J2 806" Japan 30 channels"E 863" Enercise"C 900" Cardio Theater
"A 863" Audeon"E 900" Enercise
"B 900" Broadcast Vision
5. Tap Scan to scan for available channels. The scan can take up to 10 seconds and then display
TV-1 of #. The "#" symbol is total number of strong UHF channels found. Some of these channels
may not be signals from the TV transmitters and need to be deleted.
Review channels
1.
Tap Up or Down to listen to available channels with the headphones.
2. Delete unwanted channels by pressing Delete to delete channel. Repeat process for additional
unwanted channels.
3. Adjust the Near/Far setting for channels that are available but not showing.
a) Press Far to change the setting from FAR to NEAR.
b) Press Scan to re-scan for available channels.
4.
Tap Up or Down to scroll through and verify all TV channels.
If all TV transmitters are stored, and they all correlate the TV number to the correct TV heard, setup
is complete. If not you may need to re-scan or adjust the transmitter codes (see documentation for
your transmitters to perform a code change.)
5.
Exit Set Up Mode by tapping the Toolbox icon, then tap the Home icon . The screen will
refresh.
Transmitter setup complete.
Page 39 of 261
Cybex 770T/790T Treadmill Part Number
To Next Page
Loading...
Need help?
General
