CYBEX ATON 2 User Manual

The Aton 2 is allowed to touch the vehicle seat(s) in front of it, as long the
recline angle of the Aton 2 is not affected.
The best position for the child restraint is one that is recommended by your
vehicle Owner’s Manual AND allows a proper and secure installation of the
restraint every time. If possible, have an adult ride in the rear with the child in
order to monitor the child.
24
?
?
WARNING!
DEATH or SERIOUS
INJURY can occur
If possible, INSTALL the Aton 2 Base in a seating
position that will allow the Load Leg Foot to
be extended into a LOCKED position with firm
contact with the vehicle floor.
NEVER INSTALL the Aton 2 Base in a seating
position where the Load Leg, even in its shortest
position, causes the Base to be pushed up above
the vehicle seat. If necessary, the Base may be
installed with the Load Leg folded up underneath.
The REAR SEAT is the safest location for a
properly installed child restraint.
Use this child restraint in FORWARD FACING
VEHICLE SEATS ONLY.
Vehicle Seat Location Requirements

CYBEX ATON 2 Specifications

General

Height Capacity	Up to 32 inches
Base Included	Yes
Side Impact Protection	Yes
Recline Positions	Multiple
Harness Type	5-point harness
Removable Cover	Yes, machine washable
Weight Capacity	4-35 lbs
Installation Type	LATCH, Seat Belt
Safety Standards	FMVSS 213
Installation	LATCH system or seat belt
Base Compatibility	Compatible with CYBEX Aton Base 2
Stroller Compatibility	Compatible with CYBEX strollers
Additional Features	Linear Side-impact Protection (L.S.P. System)