8. Secure the top steps.
A. Place each top step in position. See Figure 4.
B. Using a Phillips head screwdriver, tighten the three screws that hold each top step in
place. See Figure 4.
9. Secure the end caps.
A. Using a Phillips head screwdriver, tighten the screw securing each end cap in place.
See Figure 3.
10. Secure the side panels.
A. Place each side panel into position slightly under the end cap and use your hand to
push all along the bottom edge of the side panel to snap it in place. See Figure 3.
11. Secure the motor cover.
A. Lower the motor cover center into position. See Figure 2.
B. Using a Phillips head screwdriver, tighten the three screws on each side. Be sure the
screws are catching the center motor cover’s holes.
Other Preventive Maintenance
Other preventive maintenance activities must be completed by a qualified service technician
at the recommended intervals listed in the Service Schedule (shown on the next page). These
activities include:
• Measure the motor brushes and replace worn motor brushes
• Rotate and replace the running deck
• Replace the running belt
• Check the current draw
• Measure motor voltage at maximum speed, with no load
NOTE: See the Service chapter of this manual for detailed procedures for the maintenance
activities listed above.
Elevation Motor Lubrication — In time the elevation motor pivot points may develop a
squeak. If a squeak is present, remove the elevation motor by following the Elevation Motor
procedure in the Service chapter. Lubricate the upper and lower bolts and the spacers with a
small amount of lithium grease. NOTE: You can buy lithium grease at an auto parts store.
Static Electricity — Depending upon where you live, you may experience dry air, causing a
common experience of static electricity. This may be especially true in the winter time. You
may notice a static build-up just by walking across a carpet and then touching a metal object.
The same can hold true while working out on your treadmill. You may experience a shock due
to the build-up of static electricity on your body and the discharge path of the treadmill. If you
experience this type of situation, you may want to increase the humidity to a comfortable level
through the use of a humidifier.
Cybex Pro+ Treadmill Owner’s & Service Manual
Preventive
Maintenance
Page 4-6
To Next Page
Loading...
Need help?
General
