Cypress EZ-USB CX3 - 1.10.7 CX3_CSI_SENSOR_SIG_VAL (Register Address: 0 x0014)

Cypress EZ-USB CX3
EZ-USB® CX3 Technical Reference Manual, Doc. No. 001-91492 Rev. *B 22
1.10.7 CX3_CSI_SENSOR_SIG_VAL (Register Address: 0x0014)
This register configures the drive value for the XSHUTDOWN and XRESET signals for the MIPI CSI-2 block.
This register is set using the CyU3PMipicsiSetSensorControl() API.
BIT
15
14
13
12
11
10
9
8
NAME
RESERVED
BIT
7
6
5
4
3
2
1
0
NAME
RESERVED
XSHUTDOWN
OUTPUT
XRESET
OUTPUT
RESERVED
Register Field
Bit
Description
RESERVED
[15:3]
RESERVED. Firmware must preserve their settings by reading them, changing
non-reserved bits, and re-writing them.
XSHUTDOWN
OUTPUT
[2]
Drive MIPI CSI-2 XSHUTDOWN Signal:
0: Drive XSHUTDOWN LOW.
1: Drive XSHUTDOWN HIGH.
The signal is only driven when CX3_CSI_SENSOR_SIG_EN (Register
Address: 0x0010) [2] is 0.
XRESET OUTPUT
[1]
Drive MIPI CSI-2 XRESET Signal:
0: Drive XRESET LOW.
1: Drive XRESET HIGH.
The signal is only driven when CX3_CSI_SENSOR_SIG_EN (Register
Address: 0x0010) [1] is 0.
RESERVED
[0]
RESERVED. Firmware must preserve their settings by reading them, changing
non-reserved bits, and re-writing them.