Cypress EZ-USB CX3 - 1.10.6 CX3_CSI_SENSOR_SIG_EN (Register Address: 0 x0010)

Cypress EZ-USB CX3
EZ-USB® CX3 Technical Reference Manual, Doc. No. 001-91492 Rev. *B 21
1.10.6 CX3_CSI_SENSOR_SIG_EN (Register Address: 0x0010)
This register enables or disables the output of the XSHUTDOWN and XRESET signals from the MIPI CSI-2
block.
This register is set by the CyU3PMipicsiInit() and CyU3PMipicsiReset() APIs.
BIT
15
14
13
12
11
10
9
8
NAME
RESERVED
BIT
7
6
5
4
3
2
1
0
NAME
RESERVED
XSHUTDOWN ENABLE
XRESET ENABLE
RESERVED
Register field
Bit
Description
RESERVED
[15:3]
RESERVED. Firmware must preserve their settings by reading them, changing
non-reserved bits, and re-writing them.
XSHUTDOWN
ENABLE
[2]
Enable MIPI CSI-2 XSHUTDOWN Signal:
0: Enables the output for the MIPI CSI-2 XSHUTDOWN signal.
1: Disables output for the MIPI CSI-2 XSHUTDOWN signal.
The signal drive value is determined by CX3_CSI_SENSOR_SIG_VAL
(Register Address: 0x0014) [2].
XRESET ENABLE
[1]
Enable MIPI CSI-2 XRESET Signal:
0: Enables the output for the MIPI CSI-2 XRESET signal.
1: Disables the output for the MIPI CSI-2 XRESET signal.
The signal drive value is determined by CX3_CSI_SENSOR_SIG_VAL
(Register Address: 0x0014) [1].
RESERVED
[0]
RESERVED. Firmware must preserve their settings by reading them, changing
non-reserved bits, and re-writing them.