DAP-1325 N300 Wi-Fi Range Extender
User Manual
Installation and Connection
Connecting to Web-based Interface
When you have configured your computer, you can access the web-based interface and configure
needed parameters (change the parameters of the wireless network, specify the settings of the
firewall, etc.).
Start a web browser (see the Before You Begin section, page 11). In the address bar of the web
browser, enter the IP address of the extender (by default, the following IP address is specified:
192.168.0.50). Press the Enter key.
Figure 17. Connecting to the web-based interface of the DAP-1325 device.
!
If the error “ The page cannot be displayed ” (or “ Unable to display the page ”/“ Could not
connect to remote server ”) occurs upon connecting to the web-based interface of the
extender , make sure that you have properly connected the extender to your computer.
If the device has not been configured previously or the default settings have been restored, after
access to the web-based interface the Initial Configuration Wizard opens (see the Initial
Configuration Wizard section, page 32).
Figure 18. The page for running the Initial Configuration Wizard.
Page 26 of 92
To Next Page
Loading...
Need help?
General
