DAP-1325 N300 Wi-Fi Range Extender
User Manual
Configuring via Web-based Interface
IPv6
Go to the IPv6 tab to change IPv6 address of the extender and configure IPv6 addresses assignment
settings.
Figure 41. Configuring local IP addresses. The IPv6 tab. The IP section.
If needed, edit the basic settings.
Parameter Description
IP
Addressing Mode
Select the needed value from the drop-down list.
Static: an IPv6 address and a prefix are specified manually.
Prefix delegation: the extender requests a prefix to configure an
IPv6 address from a delegating router.
IP address
The IPv6 address of the extender in the local subnet. By default, the
following value is specified: fd01::50. The field is available for
editing, if the Static value is selected from the Addressing Mode
drop-down list.
Prefix
The length of the prefix subnet. By default, the value 64 is
specified. The field is available for editing, if the Static value is
selected from the Addressing Mode drop-down list.
Page 47 of 92
To Next Page
Loading...
Need help?
General
