D-Link DAP-2360 - Page 33

33D-Link DAP-2360 User Manual
Section 3 - Conguration
Network
Utilization:
Aging out:
RSSI Threshold:
Data Rate
Threshold:
ACL RSSI:
ACL RSSI
Threshold:
Set the maximum utilization of this access point for service. The DAP-2360 will not allow any new clients to associate with the AP if the
utilization exceeds the value the user species. Select a utilization percentage between 100%, 80%, 60%, 40%, 20%, or 0%. When this
network utilization threshold is reached, the device will pause one minute to allow network congestion to dissipate.
Use the drop-down menu to select the criteria of disconnecting the wireless clients. Available options are RSSI and Data Rate.
When RSSI is selected in the Aging out drop-down menu, select the percentage of RSSI here. When the RSSI of wireless clients is lower
than the specied percentage, the device disconnects the wireless clients.
When Data Rate is selected in the Aging out drop-down menu, select the threshold of data rate here. When the data rate of wireless
clients is lower than the specied number, the device disconnects the wireless clients.
Use the drop-down menu to Enable the function. When enabled, the device denies the connection request from the wireless clients
with the RSSI lower than the specied threshold below.
Set the ACL RSSI Threshold.