D-Link DGS-1210-08P - SNMP > SNMP > SNMP User

Configuration D-Link Web Smart Switch User Manual
9
9
4
4
presentation of the information controlled by the on-board SNMP agent. SNMP defines both the format of the
MIB specifications and the protocol used to access this information over the network.
The default SNMP global state is disabled. Select Enabled and click Apply to enable the SNMP function.
Figure 4.111 – SNMP > SNMP > SNMP Global Settings
Trap Settings: Specifies whether the device can send SNMP notifications.
SNMP Authentication Traps: Specifies the device to send authentication failure notifications.
Device Bootup: System boot-up information.
Port Link Up / Link Down: Port connection information.
RSTP Port State Change: Events of a RSTP port state changes.
Firmware Upgrade State: Information of firmware upgrade - success or failure.
Loopback occurring and recovery: The port status of Loopback Detection.
PoE Power On / Off: The PSE port is delivering power to the PD or not.
PoE Power Error: PoE power status error.
PoE over max power budget: PoE power over budget.
SNMP > SNMP > SNMP User
This window is used to maintain the SNMP user table for the use of SNMPv3. SNMPv3 allows or restricts
users using the MIB OID, and also encrypts the SNMP messages sent out between users and Switch.
Figure 4.112 – SNMP > SNMP > SNMP User Table
User Name: Enter a SNMP user name of up to 32 characters.
Group Name: Specify the SNMP group of the SNMP user.
SNMP Version: Specify the SNMP version of the user. Only SNMPv3 encrypts the messages.
Encrypt: Specifies the Encrypt is enabled or disabled when the SNMP Version is V3.
Auth-Protocol/Password: Specify either MD5 or SHA to be the authentication protocol. Enter a password
for SNMPv3 encryption in the right column.