D-Link DGS-1210-08P - Reboot Device; Configuration Backup and Restore; Firmware Backup and Upgrade

Configuration D-Link Web Smart Switch User Manual
2
2
2
2
Reboot Device
Provide a safe way to reboot the system. Click Apply to restart the Switch.
Figure 4.12 – Tools Menu > Reboot Device
Configuration Backup and Restore
Allow the current configuration settings to be saved to a file (not including the password), and if necessary,
you can restore the configuration settings from this file. Two methods can be selected: HTTP or TFTP.
Figure 4.13 – Tools Menu > Configure Backup and Restore
HTTP: Backup or restore the configuration file to or from your local drive.
Click Backup to save the current settings to your disk.
Click Browse to browse your inventories for a saved backup settings file.
Click Restore after selecting the backup settings file you want to restore.
TFTP: TFTP (Trivial File Transfer Protocol) is a file transfer protocol that allows you to transfer files to a
remote TFTP server. Specify TFTP Server IP Address with IPv4 or IPv6 address and TFTP File Name for
the configuration file you want to save to or restore from.
Click Backup to save the current settings to the TFTP server.
Click Restore after selecting the backup settings file you want to restore.
NOTE: The
Switch will reboot after
restore, and all current configurations will
be lost
Firmware Backup and Upgrade
Allow for the firmware to be saved, or for an existing firmware file to be uploaded to the Switch. Two methods
can be selected: HTTP or TFTP.